RPSB 1800/1802 Installation Guide
51
Appendix C: Integrating a Video Camera and
Shelf
To integrate a video camera and shelf, you must first gain access to the cabinet interior by
removing the Rear Access Panel and Lower Baffle Door as described on page 8 of this guide.
You do
not
need to remove the SMART Board screen.
NOTE
: The camera shelf may be mounted on either side of the cabinet. We recommend that
you mount it opposite the optional Flip-Up Shelf.
To integrate a video camera and shelf:
1. From inside the cabinet, push out the Hole Cover found on the top side of the cabinet near
the screen. From the outside, remove the three Shelf Mounting Screws around the Hole
Cover using the 1/8” Allen key provided. Keep these screws for use in Step 2.
2. Place the Camera Shelf over the large hole and fasten it to the cabinet with the three Shelf
Mounting Screws removed in Step 1.
3. If your camera has a standard 1/4-20 camera mount, use the 1/4-20 Screw provided to
mount the camera through one of the series of holes on top of the Camera Shelf. Use the
3/16” ball driver which came with the cabinet. Depending on the height of the camera’s
feet, you may need to use some of the Washers provided to adjust the height of the screw.
4. Connect the camera cables to the camera. Route the cables beneath the shelf and
through the large hole in the side of the cabinet.
1. From inside the cabinet, find the optimal route to keep the wires snug to the inside of the
cabinet. Use the Adhesive Cable Ties provided. If necessary use the extension cables
provided to connect to your computer.
2. Install the Camera Shelf Light Baffle with the two screws provided. Use the 1/8” Allen key
provided.
5.
Adhesive
Cable Ties
1.
Hole Cover
2.
Shelf Mounting
Screws and
Camera Shelf
3.
1/4-20
Mounting Screw
and Washers
6.
Camera Shelf
Light Baffle
4.
Camera Cables
Cut-Away View of Cabinet
