RPSB 1800/1802 Installation Guide
44
Appendix A: Maintenance and Transportation
Cleaning Cabinet Components and Mirrors
Mirrors and cabinet components should be periodically dusted using a soft cloth. All mirrors
can be lightly cleaned using a standard glass cleaner and a soft, clean cloth.
The rear surface of the SMART Board is well-protected from handling by its location on the
inside of the cabinet. However, if it must be dusted, or if a mark has been made on its surface,
it can be wiped gently with a soft cloth and standard glass cleaner.
Do not spray the glass
cleaner directly onto the surface
; spray it
lightly
on the cloth, then gently dab the back surface
of the SMART Board until the marks are removed.
WARNING
: Do not, under any circumstances, apply isopropyl alcohol, varsol, water or acetone
to the rear surface of the SMART Board. If any of these fluids come into contact with this
surface, the SMART Board becomes unusable.
Cleaning the Writing Surface
To clean the writing surface of the SMART Board, use a standard glass cleaner. Spray the
cleaning fluid on the SMART Board surface and immediately wipe with a paper towel or soft
cloth. If a permanent marker has been used, try rubbing the spot with a cloth dampened with
isopropyl alcohol. Then use a standard glass cleaner to thoroughly clean the surface.
Preventing Damage to the Writing Surface
While the SMART Board is very durable, sharp objects can scratch or cut the surface. Sharp
writing instruments, such as ball point pens or fine-pointed pens, can damage the surface if
enough pressure is applied. Keep these types of pens away from the SMART Board, and avoid
abrasive erasers and cleaning materials.
Transporting the RPSB System
When you transport the RPSB, it is important to ship the cabinet in the upright position only. In
addition, the SMART Board should never be laid face down.
Follow the preparation procedures outlined below and the RPSB should arrive at its destination
without mishap.
To prepare the RPSB for transport to another room:
1. Unlock the cabinet’s casters by pushing up on the caster locks.
2. Disconnect power, communications and network cables as necessary.
3. Slide the Pen Tray shelf in and close the Pen Tray shelf door.
4. Return the rear mirror of the RPSB 1800/1802 to its original transport position:
•
Rotate the lower baffle door until it stops.
