RPSB 1800/1802 Installation Guide
47
3. Disconnect the MOD4 cable at the bottom center of the screen.
4. With the aid of another person, remove the screen from the cabinet by lifting it up, then
out from the keyholes at the top of the side brackets.
WARNINGS
:
•
Do not touch the inside surface of the screen!
This surface is easily smudged
and very difficult to restore. You should also
protect it from anything that might
scratch or harm it.
If you do inadvertently smudge this surface, wipe it carefully
with a soft cloth and alcohol-free glass cleaner.
Do not spray the glass cleaner
directly onto the surface
; spray it
lightly
on the cloth, then gently rub the back
surface of the SMART Board until the marks are removed.
•
Do not use isopropyl alcohol, varsol, water or acetone to clean this surface!
These substances will render your SMART Board unusable.
5. Remove the screen mounting bracket at the top to the cabinet, as shown in the figure
below. The three mounting screws are fastened from inside the cabinet. Use the 1/8"
Allen key provided with the cabinet.
6. To reconnect the SMART Board to the cabinet, re-attach the top screen mounting
bracket loosely.
7. Locate the two corner studs and lift the Board up and onto the cabinet key holes via
the two back studs (see diagram on opposite page for key hole and stud locations).
8. Replace the two upper cap screws and lock washers previously removed from the
corners.
9. Once all screws are aligned, tighten the cap screws and upper bracket screws
securely.
TIP
: You may need to lift the Board slightly to align the four cap screws to their
appropriate holes.
Mounting Bracket
Mounting Bracket Screws
(center and both sides)
Removing the Mounting Bracket
