SMART LightRaise 60wi, User Manual

Page: 96 / 108

C H A P T E R 9
Connecting your room control system to your interactive projector
88 smarttech.com/kb/170295
Command Command target range Response
set micvolume [target] =0 to =40 micvolume=[target]
set mute [target] =on
=off
mute=[target]
set volumecontrol [target] =on
=off
volumecontrol=[target]
set cc [target] =cc1
=cc2
cc=[target]
set lineoutenable [target] =on
=off
lineoutenable=[target]
set micenable [target] =on
=off
micenable=[target]
set speakerenable [target] =on
=off
speakerenable=[target]
set microboostenable =on
=off
microboostenable=[target]
N O T E
Typically, cc1 displays U.S. English subtitles, while cc2 displays other regional languages, such
as French or Spanish, depending on television channel or media setup.
Network controls
These commands control your projector’s network status and settings. These settings are located in
the OSD menu, and are available even when the projector is in Standby mode. You must locally set
the network commands to on for the network abilities to work
These commands inform you of the current network settings.
Command Response
get netstatus netstatus=connected
netstatus=disconnected
netstatus=disabled
get network network=[current VGA and network outputs status]
get dhcp dhcp=[current DHCP status]
get ipaddr ipaddr=[current IP address]
get subnetmask subnetmask=[current subnet mask number]