SMART LightRaise 60wi, User Manual

Page: 89 / 108

C H A P T E R 9
Connecting your room control system to your interactive projector
81 smarttech.com/kb/170295
3. Configure your serial interface settings using the values from the table in the previous section,
and then press ENTER.
An “invalid cmd= ? for help” message appears, and the > character appears as a command
prompt on the following line.
N O T E
If no message or an error message appears, your serial interface configuration isn’t correct.
Repeat step 3.
4. Type commands to configure your settings.
N O T E S
o
To see a list of commands available in the current operating mode, type ? and then press
ENTER.
o
If you’re using a terminal emulation program, turn on your program’s local echo setting to
see characters as you type them.
Command inventory
Your projector responds to the commands in the tables on the following pages. To see a list of valid
commands in the projector’s current power state, type ? and press ENTER.
I M P O R T A N T
l
When entering commands, ensure there is a 10 millisecond delay between characters for
reliable operation.
l
Type commands exactly as they appear in the left column of the tables, with the proper value
or setting in the center column.
N O T E S
l
Send a command only after the projector sends a command prompt.
l
Commands aren’t case sensitive.
l
Check your entries carefully before entering your commands.
l
Press ENTER after typing each command.
l
After the projector executes a command, it generates a response.
l
In standby mode, only the "Power on" message is available.