![background image](http://html1.mh-extra.com/html/silverline/423352/423352_manual_1273187008.webp)
GB
8
Problem
Possible cause
Solution
Lithium Jump Starter will not switch OFF
when pressing the Power Button (2)
The automatic switch off
Leave the device unplugged from cables and all other devices for approximately 30–40 seconds, and the unit
should switch off automatically
The Lithium Jump Starter will not switch
ON when pressing the Power Button
The Lithium Polymer Battery Pack (1)
has no charge
Charge the unit using the supplied AC power supply. If after charging the device does not switch on, it may
have reached the end of the battery life and will need to be disposed of in accordance with local authorities
(see ‘Disposal’)
During charging, the Lithium
Jump Starter stops charging and
begins beeping
There is a problem with the charging
procedure; the Lithium Polymer Battery
Pack has detected a problem
1. Press and hold the Power Button for 10–30 seconds to force the continuation of charging and possibly correct
the charging issue
2. After pressing and holding the Power Button, disconnect the charger from the wall and allow the Lithium
Jump Starter to reset
3. Reconnect the charger to the Lithium Jump Starter to see if the unit will charge again normally
4. If the unit again discontinues charging and begins beeping, IMMEDIATELY DISCONNECT the power supply
and discontinue use. Consult an authorised Silverline technician
Note:
After pressing and holding the Power Button during this process, the LED Light (6) will come on, which is
normal. After disconnecting the charger, the LED Light may be turned OFF (see ‘Using the Torch/Beacon/Strobe/
SOS LEDs’) before reconnecting the charger
The Lithium Polymer Battery Pack
becomes hot to touch during use/
begins to swell
The Lithium Polymer Battery Pack
is faulty
IMMEDIATELY DISCONNECT the power supply/cables and discontinue use. Consult an
authorised Silverline technician
Troubleshooting
423352_Manual.indd 8
26/07/2018 15:59