Installation and User Manual
EtherHaul
1200™
EH-INST-02, Issue 4.0
Page 97
The following command creates a Component MA and assigns VLAN 200 as its Service
Selector.
set cfm-ma-comp c3 2 2 vlan 200
The following command creates a Maintenance End Point (MEP).
set cfm-mep 2 2 2 interface eth1 dir up cci enabled
The following command creates a Peer MEP.
set cfm-peer-mep-create 2 2 1
The following command sets the MIP to the lower level.
set cfm-ma-comp c3 2 2 vlan 200 mhf-creation explicit
Checking the CCM Status
show cfm-peer-mep
cfm-peer-mep 1 1 1 2 state : ok
<---ok or failed
cfm-peer-mep 1 1 1 2 failed-ok-time : 0000:02:22:05
cfm-peer-mep 1 1 1 2 mac : 00:24:a4:00:01:e1
cfm-peer-mep 1 1 1 2 rdi : off
cfm-peer-mep 1 1 1 2 port-status : unknown
cfm-peer-mep 1 1 1 2 if-status : unknown
cfm-peer-mep 1 1 1 2 chassis-id-subtype : unknown
cfm-peer-mep 1 1 1 2 mng-addr-domain : unknown
cfm-peer-mep 2 2 1 2 state : ok
cfm-peer-mep 2 2 1 2 failed-ok-time : 0000:02:22:05
cfm-peer-mep 2 2 1 2 mac : 00:24:a4:00:01:e2
cfm-peer-mep 2 2 1 2 rdi : off
cfm-peer-mep 2 2 1 2 port-status : unknown
cfm-peer-mep 2 2 1 2 if-status : unknown
cfm-peer-mep 2 2 1 2 chassis-id-subtype : unknown
cfm-peer-mep 2 2 1 2 mng-addr-domain : unknown
Configure the Loopback on the Local ODU
The following set of commands sets up the Loopback on the local ODU. You must set the
destination type (mepid or mac) and the destination MEP ID, determine the number of
loopback packets to transmit, and enable the Loopback for transmit.
Enter the following commands on the link level:
set cfm-mep 1 1 1 lbm-dst-type mepid
set cfm-mep 1 1 1 lbm-dst-mepid 2
set cfm-mep 1 1 1 lbm-tx-num 10
set cfm-mep 1 1 1 lbm-tx-status tx-pending
