Installation and User Manual
EtherHaul
1200™
EH-INST-02, Issue 4.0
Page 35
Figure
2-6
shows the EtherHaul 1200 after it has been completely installed.
Figure
2-6 Installed EtherHaul 1200 Unit
2.9
Performing Initial System Setup
Note:
The instructions in this section refer to
Figure
2-1
.
1.
Disconnect the DVM from the ODU by removing the probes from the AUX port
(
Figure
2-2)
.
2.
Reboot both ODUs by gently pressing the ODU Reset Button (
). This returns
the ODU to
Adaptive
Mode.
Following this action, and after the ODU has
finished rebooting, the RF LED color indicator on both ODUs will turn
green,
indicating that the radio link is Up.
3.
Carefully reinsert and tighten using the 13mm open wrench the AUX port
protective seal.
The EtherHaul 1200 link can now pass traffic and management between the ports
and over the radio link.
Further configuration can be performed using the Web EMS or the CLI.
Note:
To perform configuration and monitoring, you must connect your laptop or PC to one
of the two Ethernet ports on the ODU.
