Siemens SITRANS LR 300, Instruction Manual, Page: 62 / 140

Page 60 SITRANS LR 300 – INSTRUCTION MANUAL 7ML19985CL02
mmm
mm
Pa
ra
m
et
er
s
P051 Maximum Volume (F = 100 i.e. 100%)
For readings in volumetric units (rather than percent), enter the vessel volume between
Empty (P006) and Span (P007).
The units of measurement for this reading are non-dimensional. The volume is calculated
from the empty position to the maximum position and is scaled according to the Tank
Shape (P050) value. This allows the use of any volume units required.
Example:
1. If maximum volume = 3650m
3
, enter 3650.
or
2. If maximum volume = 267500 gallons, enter 26750 (gallons x 10).
3. Enter the volume of the tank at full (Factory Setting = 100).
P052 Tank Dimension A (F = – – – –)
Dimension A is used in the tank shape parameter (P050) on page 58.
If P050 = 2,3,4, or 5, enter the height of the tank bottom.
If P050 = 7, enter the length A of one end-section of the tank. (See chart “Tank Shape” on
page 59.)
P053 Tank Dimension L (F = – – – –)
Dimension L is used in the tank shape parameter (P050) on page 58.
If P050 = 7, enter the tank length L (excluding both end sections). (See chart “Tank Shape”
on page 59.)
Values
Range: 0.0000 to 99999
Related Parameters
P006 Empty
P007 Span
Values
Range: 0.0000 to 99999 in units (P005)
Related Parameters
P050 Tank Shape
Values
Range: 0.0000 to 99999 in units (P005)
Related Parameters
P050 Tank Shape
Note
:
Enter the dimension in units chosen in P005.
Note
:
Enter the dimension in units chosen in P005.
SITRANS LR 300.book Page 60 Monday, June 10, 2002 7:18 PM