Siemens SITRANS LR 300, Instruction Manual, Page: 111 / 140

7ML19985CL02 SITRANS LR 300 – INSTRUCTION MANUAL Page 109
m
mmmm
Appendix VI
HART Communicator 275:
Chart 1
1. Level
2. AO
3. Device Setup
4. Refresh
1. Reset + Config
2. Display
3. Diagnostics
4. PV Exchange
5. Device Data
6. Serial Comm RS 485
7. Review
1. Master Reset
2. Quick Setup
1. Level
2. Space
3. Distance
4. Volume
5. AO
6. Refresh
1. Wear
2. Status
3. Self Test
4. Range Calibration
5. Trim Analog Output
6. Simulate AO
1. Read Analog Out
2. Select Analog Out
1. Units
2. Basic Setup
3. Detailed Setup
4. Output param
5. Device information
6. HART information
1. Protocol
2. Address
3. Baud
4. Parity
5. Data Bits
1. Run Time
2. Startups
3. Max Int temp
4. Min Int temp
1. Sensor status
2. Electronics status
3. Software status
4. Application status
1. Self Test
1. Offset
2. Prop factor
3. Min reading
1. D/A trim
2. Scaled D/A trim
1. Length unit
2. Refresh
1. 4 mA
2. 20 mA
3. Other
4. End
Basic Setup (See Chart 2 )
Detailed setup (See Chart 3)
Output parameter (See Chart 4 )
On Line Device Setup Reset and Config Wear
1. Hardware/firmware fail
2. Diagnostic warn
3. Reading question
4. Simulation mode
1. RAM failure
2. ROM failure
Electronics Status
Sensor Status
Software Status
1. Calib error
2. Temp out of range
Application Status
1. Loss of echo
2. LOE Failsafe
Status
Display
Range Calibration
Trim Analog Output
Simulate AO
Diagnostics
PV Exchange
Device Data
Serial Comm RS 485
Units
Device information
1. Tag
2. Descriptor
3. Message
4. Final asmbly num
5. Last config
6. Manufacturer data
HART information
1. Manufacturer
2. Model
3. HART Dev. I.D.
4. Universal rev.
5. Fld. dev. rev.
6. Software rev.
7. Hardware rev.
Manufacturer data
1. Serial No. Sens
SITRANS LR 300.book Page 109 Monday, June 10, 2002 7:18 PM