Wiring
6.8 Front connector for the I/O modules
ET 200MP Distributed I/O System
System Manual, 01/2013, A5E03723484-01
67
Components of a front connector for I/O modules with shield contact element
The shielding bracket, the power supply element, and the shielding clamp are included in the
scope of delivery for the analog and technology modules.
The following figure shows the components of a front connector:
①
Shield clamp
⑥
Power supply element
②
Cable sheathing removed (approx. 20
mm)
⑦
Shielding bracket
③
Strain relief (cable tie)
⑧
Supply lines
④
Signal cables
①
+
⑦
Shield contact
⑤
Front connectors
Figure 6-6
Components of a front connector for I/O modules with shield contact element
Preparing front connectors for I/O modules with shield contact element
Watch video sequence (
1.
Remove the connection separator from the lower part of the connector (Figure 1).
2.
Insert the power supply element (Figure 2).
3.
Insert the shielding bracket from below into the front connector until it latches into place
(Figure 3).
Summary of Contents for simatic ET 200MP
Page 4: ...Preface ET 200MP Distributed I O System 4 System Manual 01 2013 A5E03723484 01 ...
Page 8: ...Table of contents ET 200MP Distributed I O System 8 System Manual 01 2013 A5E03723484 01 ...
Page 118: ...Service Support ET 200MP Distributed I O System 118 System Manual 01 2013 A5E03723484 01 ...
Page 126: ...Index ET 200MP Distributed I O System 126 System Manual 01 2013 A5E03723484 01 ...
