Wiring
6.8 Front connector for the I/O modules
ET 200MP Distributed I/O System
72
System Manual, 01/2013, A5E03723484-01
6.8.4
Bringing the front connector into final position
Bring the front connector from the pre-wiring position into final position
1.
Grip the front connector by the unlocking strap.
2.
Pull on the strap until the front connector is released from its latched position.
3.
Tilt the top section of the front connector and raise it slightly. The front connector slides
over the guide channel into its final position.
Figure 6-7
Bring the front connector from the pre-wiring position into final position
4.
Push the front connector back into the module until it latches. The front connector is now
electrically connected with the module.
5.
Swivel the front cover down into place. Depending on the space requirement of the cable
harness, various latch positions are possible, so that the required cable storage space
can grow as needed.
Summary of Contents for simatic ET 200MP
Page 4: ...Preface ET 200MP Distributed I O System 4 System Manual 01 2013 A5E03723484 01 ...
Page 8: ...Table of contents ET 200MP Distributed I O System 8 System Manual 01 2013 A5E03723484 01 ...
Page 118: ...Service Support ET 200MP Distributed I O System 118 System Manual 01 2013 A5E03723484 01 ...
Page 126: ...Index ET 200MP Distributed I O System 126 System Manual 01 2013 A5E03723484 01 ...
