Wiring
6.9 Marking the I/O modules
ET 200MP Distributed I/O System
74
System Manual, 01/2013, A5E03723484-01
6.9
Marking the I/O modules
6.9.1
Labeling strips
Introduction
Mark the pin assignment of the I/O modules using labeling strips. The labeling strip can be
written on as desired, and is slid into the outside of the front cover.
The labeling strips are available in the following models:
●
Ready-made strips for manual inscription, that are included with the module in the
delivery condition.
●
DIN A4 sheets, pre-perforated strips for machine printing. See the chapter Accessories /
Preparing and installing the labeling strip
1.
Label the labeling strip.
2.
With a pre-perforated strip: Separate the labeled strip from the sheet.
3.
Slide the labeling strip into the outside of the front cover.
①
Labeling strips
Figure 6-9
Marking with labeling strips
Summary of Contents for simatic ET 200MP
Page 4: ...Preface ET 200MP Distributed I O System 4 System Manual 01 2013 A5E03723484 01 ...
Page 8: ...Table of contents ET 200MP Distributed I O System 8 System Manual 01 2013 A5E03723484 01 ...
Page 118: ...Service Support ET 200MP Distributed I O System 118 System Manual 01 2013 A5E03723484 01 ...
Page 126: ...Index ET 200MP Distributed I O System 126 System Manual 01 2013 A5E03723484 01 ...
