Siemens FIDAMAT 6, Operating Instructions Manual, Page: 80 / 202

Functions
8.2 Analyzer status
FIDAMAT 6
78
Operating Instructions, 01/2019, A5E00222135-04
8.2.4 Logbook (function 3)
In the logbook, all errors which led to a maintenance request (W) or a fault (S) are listed.
The limit alarm (LIM) and functional check (CTRL) are also registered. However, these do
not trigger a maintenance request or fault message.
The logbook contains a max. of eight pages, with four messages per page. It works
according to the rotating buffer principle, i.e. when all eight pages (all 32 locations) are
occupied, the oldest message is overwritten.
You can delete or block logbook entries (function 60), but you can also switch them off
individually (function 87).
Note
If an error occurs whose error message is switched off with function 87, there is no reaction
at any configured interface. This applies both to the ELAN interface and to the analog output
and the relay output.
In case of servicing, function 110 (diagnostics service) is to be observed as well. However,
this function is only accessible to service engineers.
See also
Logbook settings (function 60) (Page 103)
Error on/off (function 87) (Page 127)
List of maintenance requests (Page 139)
List of faults (Page 140)
8.2.5 Display measuring ranges (function 4)
The measuring ranges defined using function 41 are listed here. However, you cannot carry
out any changes in this function.