Siemens FIDAMAT 6, Operating Instructions Manual, Page: 109 / 202

Functions
8.6 Configuration
FIDAMAT 6
Operating Instructions, 01/2019, A5E00222135-04
107
Note
If the electronics is defective, it is possible for the analog output to become stuck at approx. -
1 mA or approx. +24 mA.
8.6.3 Relay outputs (function 71)
Figure 8-42 Assigning the relays
There are six freely configurable relays included in the standard equipment whose
switchable output contacts (max. 24 V/1 A) can be used for signaling, actuating valves, etc.
If these six relays are insufficient, you can add eight more relays through additional
electronics (option board).
With this function, you assign one of the functions listed in the table "Relay outputs (possible
functions)" to each relay, whereby you may only assign each function once. In other words,
for example, "Fault" may not be assigned to two relays at the same time.
The connection assignments for the individual relays in the zero-current state can be found
in the terminal diagram "Motherboard pin assignment". The relays are preset at delivery.
Press the fifth softkey ("...cont."), to access the next function screen, thus branching to
further relays.
Table 8- 5 Relay assignment (possible functions)
Function Relay is passive when Relay conducts cur-
rent
Note
Not assigned Relay is permanently pas-
sive (zero current)
Fault Fault Also shown in status line of
measured value display
Maintenance request Maintenance request Also shown in status line of
measured value display
Calibration Calibration running For identification purposes