Siemens FIDAMAT 6, Operating Instructions Manual, Page: 180 / 202

Appendix
A.4 Overview of operating functions
FIDAMAT 6
178
Operating Instructions, 01/2019, A5E00222135-04
during maintenance work). Handle the modules without touching any chip pins or PCB
traces. In this way, the discharged energy can not affect the sensitive devices.
Discharge your body before you start taking any measurements on a module. Do so by
touching grounded metallic parts. Always use grounded measuring instruments.
A.4 Overview of operating functions
The device functions are listed in the following overview. This list corresponds to software
version V1.3.6.
Table A- 1 Overview of operator control functions
Submenu Function Name of function
Analyzer status 1 Analyzer configuration
2 Diagnostic values
3 Logbook
4 Display meas. ranges
Calibration (code 1) 20 Zero calibration
21 Span calibration
22 Setpoints for zero/ span
23 Calibration settings (single/total range calibration)
24 AUTOCAL/-check (only with option board)
25 Drift values
Measuring ranges (code
1)
40 Range selection
41 Define meas. ranges
Parameters (code 1) 50 El. time constants
51 Limits
52 On/off configuration
53 Status messages
54 G. signal display
55 Select digits
56 LCD contrast
57 Ignite flame
58 Date/Time
59 Sample selection
60 Setup logbook
61 Int. valves
62 Adjust external pressure (FIDAMAT 6-G only)
Configuration (code 2) 70 Analog output
71 Relay assignment
72 Binary inputs
73 ELAN configuration
74 Reset