![background image](http://html.mh-extra.com/html/sick/vms4200/vms4200_addendum-to-operating-instructions_1264378077.webp)
MOUNTING
4
77
8026365/V1-0/2022-03|SICK
Subject to change without notice
S U P P L E M E N T A R Y O P E R A T I N G I N S T R U C T I O N S | VMS4200-x/5200-x MID
•
The LiDAR sensors are mounted above the conveying equipment using the mounting
kit included in the scope of delivery.
•
The mounting kit has a modular design and is preconfigured accordingly upon delivery.
•
It consists of a width-adjustable telescopic tube with pre-mounted and pre-aligned
mounting plates to hold the LiDAR sensors.
•
The telescopic tube is attached to the customer’s frame via a pre-mounted attachment
mechanism, consisting of a mounting plate and a spring plate.
▸
Assemble the profiles of the telescopic tube.
▸
Mount the telescopic rod on the frame.
Fasten the LiDAR sensor to the mounting plate
NOTE!
Adjustment after mounting is not required. The LiDAR sensors have been correctly
pre-aligned at the factory by adjusting the orientation of the retaining plates on the
telescopic rod.
If an alternative attachment method is used (e.g., mounting the LiDAR sensors on a
hollow shaft), adjustment will be required.
4.1.2
Assembling profiles of the telescopic tube
Fig. 73: Assembling profiles of the telescopic tube
Legend
1
Main tube
2
Right and left telescopic tube
▸
Slide the right and left telescopic tubes into the main tube and fasten them with
screws.
▸
Adjust the tube to the desired width with the help of the markings.
Fig. 74: Markings on the telescopic tube
Mounting kit
Installation steps
Mounting