*640072*
640072
Models 8230 & 8240
Electro-Mechanical
Swing Operator
Installation Instructions
Table of Contents
General ...........................................................................................................................................................................................................1
Replacement Parts & System Components ...................................................................................................................................................1
1 Pre-Installation Site & Product Check..........................................................................................................................................................2
2 Operator Installation ....................................................................................................................................................................................3
3 Wiring...........................................................................................................................................................................................................5
4 Arm & Cover Installation ..............................................................................................................................................................................5
5 Operational Check .......................................................................................................................................................................................7
6 Operator Adjustment ....................................................................................................................................................................................8
7 Release For Service ..................................................................................................................................................................................10
8 Falcon Software .........................................................................................................................................................................................10
General
The Falcon Operator is a low energy automatic electromechanical swinging door operator for use on hinged, center pivoted and offset
pivoted doors. When activated, the Falcon drives the door to full open position, then electrical power is turned off and the door is closed
by spring force. The activating circuit opens the door from any position in the closing swing. During a power failure, the Falcon Operator
acts as a manual door closer (Size 3). Door opening and closing cycles, including opening speed, back check speed, hold open time
delay, closing speed, latch position, and backcheck position are adjustable.
WARNING
Always disconnect main power to the
operator prior to servicing or cleaning.
CAUTION
This operator is for indoor use only.
CAUTION
Do not mount any accessories directly
to the operator.
Replacement Parts & System Components
Part
26” Header
Control Box
8230-3462
8240-3462
Gear Box
8230-3454
8240-3462
Part
Pull
Standard Push
Finish
Arm Assembly
8230-3077T
8240-3077
AL689
26” Pull System
(screw pack not shown)
26” Push System
(screw pack not shown)
Pull arm -3077T
and track -3038
Arm & track assy -3077PLCM
Summary of Contents for 8230
Page 12: ......
