![background image](http://html.mh-extra.com/html/sick/vms4200/vms4200_addendum-to-operating-instructions_1264378110.webp)
7
MAINTENANCE AND REPAIR
110
8026365/V1-0/2022-03|SICK
S U P P L E M E N T A R Y O P E R A T I N G I N S T R U C T I O N S | VMS4200-x/5200-x MID
Subject to change without notice
Fig. 95: Dowel pins and locating holes
▸
Press the device into place with one hand and screw the device to the mounting plate.
▸
Make sure that the device is securely screwed on.
▸
Screw the connecting cables back on.
▸
Switch the voltage supply back on.
▸
Check that the status LED lights up green after approximately 40 seconds.
▸
Conduct a test run and check whether the multi-dimensional measurement system is
providing plausible measurement results.
NOTE!
It may be necessary to recalibrate the exchanged LiDAR sensor using SOPAS.
▸
After replacing a component, contact the manufacturer.
▸
The manufacturer will arrange for the system to be reverified after the replacement of
a component.
Mounting the
replacement device
Test run
Restoring
MID conformity