SICK TRANSIC111LP, Operating Instructions Manual

Page: 44 / 108

44 8014084/ZWT7/V3-1/2020-06 | SICK O P E R A T I N G I N S T R U C T I O N S | TRANSIC111LP
Subject to change without notice
4
OPERATION
4.7.7 Display/define serial communication settings (command SERI)
Sets the parameters for serial communication.
Valid baud rates for the maintenance interfaces are 300, 600, 1200, 2400, 4800, 9600,
19200, 38400, 57600 and 115200. The maximum baud rate for the RS-485 interface is
38400.
Syntax: SERI [Baud] [Data] [Parity] [Stop]<cr>
Example:
4.7.8 Display/set serial communication for RS-485 (command SERI2)
Defines the parameters for the RS-485 interface. The command can be entered via the
maintenance interface. Valid baud rates are 300, 600, 1200, 2400, 4800, 9600, 19200
and 38400.
Syntax: SERI2 [Baud] [Data] [Parity] [Stop]<cr>
Example:
NOTICE:
This command defines the parameters of the serial interface via which the command is
entered (maintenance interface or RS-485 interface).
NOTICE:
To be able to use the new settings, save them in EEPROM with command SAVE ( see
“Save parameters (command SAVE)”, page 58 ) and then reset the device with
command RESET ( see “Reset (command RESET)”, page 59 ).
Baud =
Valid baud rates are 300, 600, 1200, 2400, 4800, 9600, 19200, 38400, 57600 and
115200 (max. baud rate for the RS-485 interface is 38400)
Data = Number of data bits (7 or 8)
Parity = Parity (n = none, e = even, o = odd)
Stop = Number of stop bits (1 or 2)
>seri
BAUD RATE : 19200 ?
DATA BITS : 8 ?
PARITY : NONE ?
STOP BITS : 1 ?
NOTICE:
To be able to use the new settings, save them in EEPROM with command SAVE ( see
“Save parameters (command SAVE)”, page 58 ) and then reset the device with
command RESET ( see “Reset (command RESET)”, page 59 ).
Baud = Valid baud rates are 300, 600, 1200, 2400, 4800, 9600, 19200 and 38400.
Data = Number of data bits (7 or 8)
Parity = Parity (n = none, e = even, o = odd)
Stop = Number of stop bits (1 or 2)
>seri2
BAUD RATE : 19200 ?
DATA BITS : 8 ?
PARITY : NONE ?
STOP BITS : 1 ?