3
2
1
Parameter Description
Parameter Description
•
If you need real sensorless vector control, you should set P.300 to 3.
Note: 1.The motor capacity has to be at the same level or one level below of the level of the capacity of the inverter.
2. For the auto-tuning function, if motor operation is permitted, set P.301 to 1 (dynamic measurement). At this
point, the load has to be separated from the motor. If the load environment does not permit auto-tuning, set
P.301 to 2 (static measurement) if motoring is running.
3. Real sensorless vector control: measurement by automatic (Auto-tuning) function to enhance the control
performance. Set the motor parameters or do auto measurement function before set P.300 to 3, in ordor to
increase the control accuracy.
5.64 Motor Parameter (P.302~P.309)
P.302 “Motor rated power”
P.303 “Motor level”
P.304 “Motor rated voltage”
P.305 “Motor rated frequency”
P.306 “Motor rated voltage”
P.307 “Motor rated rotation speed”
P.308 “Idling excitation current”
P.309 “Stator resistor”
Parameter
Factory setting
Setting range
Remarks
-
-
-
0
6
1
~
0
0
2
0
3
-
-
-
8
~
0
4
3
0
3
-
-
-
V
0
4
4
~
0
V
0
4
4
/
0
2
2
4
0
3
50Hz
P.189
=1
305
60Hz
0~650Hz
P.189=0
-
-
-
A
0
0
5
~
0
d
e
s
a
b
-r
e
w
o
p
e
s
r
o
H
6
0
3
1
=
9
8
1
.
P
n
i
m
/r
0
1
4
1
307
1710 r/min
0~9998 r/min
P.189=0
-
-
-
A
0
0
5
~
0
d
e
s
a
b
-r
e
w
o
p
e
s
r
o
H
8
0
3
309
Horsepower-based
99.98
-
-
-
<Setting>
•
When the motor can be fully separated from the load, select P.301=1. When the motor is running,
the motor parameter will carry out auto-tuning. Then press
FWD
or
REV
on the keyboard panel for the
inverter to automatically calculate the following parameter: P.308~P.309.
•
When the motor cannot be fully separated from the load, select P.301=2. When the motor is stopped,
the motor parameter will carry out auto-tuning. Then press
FWD
or
REV
on the keyboard panel for the
inverter to automatically calculate the following parameter P.308~P.309.
•
The users can use the motor's nameplate to calculate the idling current. The motor nameplate
parameters used in the calculation are: rated voltage U, rated current I, rated frequency
f
and power
factor .
Idling current:
2
0
1
I
I
