Dobot Magician User Guide
Dobot Magician Homing Operation
Issue V1.9.0 (2020-07-23)
User Guide
Copyright © Yuejiang Technology Co., Ltd.
50
Figure 5.29 Install a writing and drawing kit
NOTE
To change to a new pen, unfasten the four M3*5 set screws in the pen holder with a
1.5mm hexagon wrench, as shown in Figure 5.30.
Figure 5.30 Change to a new pen
Connecting the DobotStudio
If the current firmware of the Dobot Magician is the 3D Printing firmware instead of
the Dobot firmware, the
Select tool
dialog box is displayed, asking if you want to
switch to the Dobot firmware. In this case, perform the following steps to switch to
this firmware.
Select
DobotStudio
to upgrade the Dobot firmware, as shown in Figure 5.31.
