SEWOO WTP-100, Technical Manual

Page: 47 / 76

TECHNICAL MANUAL
ESC c 4 n
[Name]
Select paper sensor(s) to stop printing
[Format]
ASCII ESC c 4 n
Hex 1B 63 34 n
Decimal 27 99 52 n
[Range] 0≤
n ≤ 255
[Description]
Selects the paper sensor(s) used to stop printing when a paper-end is
detected, using n as follows.
Bit Off / On Hex Decimal Function
Off 00 0 Paper roll near end sensor disabled.
0
On 01 1 Paper roll near end sensor enabled
Off 00 0 Paper roll near end sensor disabled
1
On 02 2 Paper roll near end sensor enabled
2 – 7 - - - Undefined
[Notes]
When a paper sensor is enabled with this command, printing is stopped
only when the corresponding paper is selected for printing.
When a paper-end is detected by the paper roll sensor, the printer goes
off-line after printing stops.
When either bit 0 or 1 is on, the printer selects the paper roll near-end
sensor for the paper sensor to stop printing.
[Default] n = 0
ESC c 5 n
[Name]
Enable / disable panel buttons
[Format]
ASCII ESC c 5 n
Hex 1B 63 35 n
Decimal 27 99 53 n
[Range]
0≤ n ≤ 255
[Description]
Enables or disables the panel buttons.
When the LSB of n is 0, the panel buttons are enabled.
When the LSB of n is 1, the panel buttons are disabled.
[Notes] Only the lowest bit of n is valid.
TITLE : WTP-100
Page47