TECHNICAL MANUAL
[Description]
ESC SP
n sets the character spacing for the right side of the character to
[
n x (horizontal or vertical motion units) ].
This command is not effective on Kanji characters.
[Notes]
The right-side character spacing is [
n x (horizontal or vertical motion
unit)] inches.
The right-side character spacing is [
n x (horizontal or vertical motion
unit)] inches.
This command sets values independently in each mode (standard and
page modes).
The horizontal and vertical motion units are specified by
“
GS P
”
.
Changing the horizontal or vertical motion units does not affect the current
right-side spacing.
The
“
GS P
”
command can change the horizontal (and vertical) motion
unit.
However, the value cannot be less than the minimum horizontal movement
amount, and it must be in even units of the minimum horizontal movement
amount.
In standard mode, the horizontal motion unit is used.
The horizontal or vertical motion unit differs in page mode, de pending on
the starting position of the printable area as follows :
When the starting position is set to the upper left or lower right of the
printable area using
“
ESC T
”
, the horizontal motion unit (x) is used.
When the starting position is set to the upper right or lower left of the
printable area using
“
ESC T
”
, the vertical motion unit (y) is used.
Any setting exceeding the maximum is converted to the maximum
automatically.
[Default]
n = 0
[Reference]
GS P
ESC !
n
[Name]
Select print mode(s)
[Format]
ASCII
ESC
!
n
Hex
1B
21
n
Decimal 27
33
n
[Range]
0≤
n
≤ 255
[Description]
Selects print modes using
n as follows:
TITLE : WTP-100
Page25
