TECHNICAL MANUAL
[Description]
Sets the distance from the beginning of the line to the position at which
subsequent characters are to be printed.
[Notes]
The distance from the beginning of the line to the print position is [(
n
L
+
n
H
x
256) x (vertical or horizontal motion unit)] inches.
Settings outside the specified printable area are ignored.
The horizontal and vertical motion units are specified by
“
GS P
”
.
The
“
GS P
”
command can change the horizontal (and vertical) motion
unit.
However, the value cannot be less than the minimum horizontal movement
amount, and it must be in even units of the minimum horizontal movement
amount. In standard mode, the horizontal motion unit is used.
The horizontal or vertical motion unit differs in page mode, depending on
the starting position of the printable area as follows :
When the starting position is set to the upper left or lower right of the
printable area using
“
ESC T
”
, the horizontal motion unit (x) is used.
When the starting position is set to the upper right or lower left of the
printable area using
“
ESC T
”
, the vertical motion unit (y) is used.
[Reference]
ESC ＼, GS $, GS ＼, GS P
ESC % n
[Name]
Select/cancel user-defined character set
[Format]
ASCII
ESC
%
n
Hex
1B
25
n
Decimal 27
37
n
[Range]
0≤
n
≤ 255
[Description]
Selects or cancels the user-defined character set
When the LSB of n is 0, the user-defined character set is canceled.
When the LSB of n is 1, the user-defined character set is selected.
[Notes]
When the user-defined character set is canceled, the internal character
set is automatically selected.
n is available only for the least significant bit.
[Default]
n = 0
[Reference]
ESC &, ESC ?
TITLE : WTP-100
Page27
