TECHNICAL MANUAL
Normal mode or Double-height mode = 1 dot
Normal mode or Double-height mode = 1 dot
[Default]
nL
= 0,
nH
= 2
For 58mm paper width model;
nL
= 104,
nH
= 1
[Reference]
GS L, GS P
GS ＼ nL nH
[Name]
Set relative vertical print position in page mode
[Format]
ASCII GS
＼
nL
nH
Hex
1D 5C
nL
nH
Decimal 29 92
nL
nH
[Range]
0
≤
nL
≤
255
0
≤
nH
≤
255
[Description]
Sets the relative vertical print starting position from the current position in
page mode.
This command sets the distance from the current position to [(
nL
+
nH
x
256) vertical or horizontal motion unit] inches.
[Notes]
This command is ignored unless page mode is selected.
When pitch N is specified to the movement downward:
nL
+
nH
x 256 = N
When pitch N is specified to the movement upward (the negative
direction), use the complement of 65536.
When pitch N is specified to the movement upward:
nL
+
nH
x 256 = 65536 - N
Any setting that exceeds the specified printing area is ignored.
This command function as follows, depending on the print starting
position set by ESC T:
① When the starting position is set to the upper left or lower right of the
printing, the vertical motion unit (y) is used.
② When the starting position is set to the upper right or lower left of the
printing area, the horizontal motion unit (x) is used.
The horizontal and vertical motion unit are specified by GS P.
The GS P command can change the horizontal (and vertical) motion unit.
However, the value cannot be less than the minimum horizontal movement
amount, and it must be in even units of the minimum horizontal movement
amount.
TITLE : WTP-100
Page65
