TECHNICAL MANUAL
3.3 Drawer Kick-out Connector (Modular Connector)
The pulse specified by ESC p or DLE DC4 is output to this connector.
The host can confirm the status of the input signal by using the
DLE EOT, GS a, or GS r commands.
1) Pin assignments:
Refer to Table 2.2.2
2) Connector model:
Printer side:
DAEEUN DEK-623PCB-6-B or Equivalent
User side:
6-position 6-contact (RJ12telephone jack)
< Drawer Kick-out Connector Pin Assignments >
Pin Number
Signal Name
Direction
1
Frame GND
-
2
Drawer kick-out drive signal 1
Output
3
Drawer open/close signal
Input
4
+24V
-
5
Drawer kick-out drive signal 2
Output
6
Signal GND
-
+24V is output through pin 4 when the power is turned on. However, pin 4 must by
used only for the drawer.
< Figure 3.1 Drawer Kick-out Connector >
3) Drawer kick-out drive signal
Output signal: Output voltage: Approximately 24V
Output current: 1A or less
CAUTION: To avoid an overcurrent, the resistance of the drawer kick-out solenoid
must be 24 Ω or more.
Output waveform: Outputs the waveforms in Figure 3.2 to the points A and B
in Figure 3.3
t1 (ON time) and t2 (OFF time) are specified by ESC p or
DLE DC4.
TITLE : WTP-100
Page13
