SL310006593 Ed.00 - 07-2011
- 20_EN -
8. SCRAPPING
Electric and electronic equipment must be disposed of in ac-
cordance with European Directive 2002/96/EC.
Such equipment may not be disposed of as normal municipal solid
waste but must rather be separately collected to optimise recovery
and recycling of the materials used to manufacture them.
All products are marked with the crossed out wheeled bin
symbol as
a reminder of separate collection obligations.
Correct observance of all of the provisions for the disposal of end-of-life prod-
ucts will contribute to safeguarding the environment.
9. TROUBLESHOOTING
Problem
Cause
Remedy
The machine does not turn on.
The main switch is off (positioned on “O”). (Cap.6)
Press the switch into position “I”.
The machine is not plugged in.
Insert the plug in a suitable outlet.
The tap leaks (liquid leaks from below).
The tap plug is not lubricated. (Fig.41)
Lubricate the cap
The plug is defective.
Replace the plug.
Product leaks from the rear part of the bowl. The bowl is not fi t correctly in place . (Par.7.5)
Check the positioning of the bowl.
The bowl seal is not lubricated. (Fig.36)
Lubricate accordingly.
The seal is defective.
Replace the seal.
The auger does not turn
The switch is positioned on “O”. (Cap.6)
Press the switch into position “I”.
Blocks of ice inside the bowl.
Switch off the machine, allow the bowl contents to melt
and check that the product has been correctly diluted.
The machine does not make granita.
The switches are off. (Cap.6)
Press the switch into position “I”.
The machine is near sources of heat.
Install the machine in a suitable place.
There is insuffi cient ventilation.
The condenser is dirty. (Par.7.9.1)
Call in a specialized technician to clean the
condenser.
The consistency has not been regulated correctly.
(Par.6.5)
Correctly regulate the consistency.
The auger is noisy.
The front seal has been applied incorrectly. (Fig.35)
Check that the seal is applied correctly.
The seal is not lubricated. (Fig.36)
Lubricate the seal accordingly.
The tap does not dispense
Blocks of ice inside the bowl.
Switch off the machine, allow the bowl contents to melt
and check that the product has been correctly diluted.
The display visualises A1 or A2
Sensor malfunctioning
Contact the specialist technician.
The display visualises A3 and the
machine stops
The product in the tank is too chilled.
Switch off the machine. Wait for the product to warm a lit-
tle. Switch the machine again and reduce the regulation
of the product density.
The display visualises A4 and the
machine stops
The lid on the tank is not in position.
Reposition the lid on the tank.
If the problem persists after repositioning the lid, contact
the specialist technician.
If the machine malfunctions due to causes other than those listed in this table or the proposed remedies do not solve the problem, contact a specialized
technician.
Summary of Contents for Granita machine
Page 24: ...SL310006593 Ed 00 07 2011 22_IT...
Page 46: ...SL310006593 Ed 00 07 2011 22_ES...
Page 48: ...SL310006593 Ed 00 07 2011 24_ES...
Page 50: ...SL310006593 Ed 00 07 2011 26_ES...
