Sencotel Granita machine, Operating Instructions Manual

Page: 68 / 111

SL310006593 Ed.00 - 07-2011 - 18_EN -
7.7. Cleaning the drip tray
The drip tray should be emptied and cleaned daily.
Note: all of the drip trays present in the machine should be
cleaned.
Holding the drainage hose fi rmly, lift the tray with the grid on top of it and pull
it out.
Wash the tray and grid separately with lukewarm water.
Dry all of the components.
Reposition the grid on top of the tray.
Position the drainage hose in the opening provided.
Fit the tray back in place and press down to secure it to the machine.
Fig.42
Fig.43
Fig.44
Fig.45
7.8. Lighted lid
Maintenance of the lighted lid must be entrusted solely to a
specialized technician, who must organize all of the operation-
al sequences and use suitable equipment, in strict compliance
with the applicable regulations currently in force.
The operator is forbidden to disassemble any lid component.
Clean the lid contacts using a wet cloth, and dry carefully. Always
carry out this operation when the machine is off.
7.8.1. Bulb replacement
The bulb must be replaced only when the main switch is in posi-
tion -0- and power cord is unplugged.
remove the protection caps; undo both screws to split the lighted lid sections;
use a proper screwdriver for this operation.
Remove the bulb “U” from the socket “T” , and replace it with a new one.
Refi t the lid, and tighten both screws.
Warning: during the cleaning operations, take care not to dam-
age (bend, break, etc.) the contacts; any damage might cause a
bad functioning of the lid, which is not under warranty.
7.9. Cleaning the condenser
The condenser may be cleaned solely by a specialized techni-
cian, who must organize all of the operational sequences and
use suitable equipment, in strict compliance with the applica-
ble regulations currently in force.
Periodically clean the condenser situated inside the machine.
Warning: Removing safety guards will expose some sharp sur-
faces of the machine.
A dirty condenser will impair machine performance.
To access the condenser remove the safety guards.
It is forbidden to use the machine when even only one panel
(front, rear or side) is not set properly in place. It is prohibited
for the operator to clean the condenser.