Seip TS Akku II, Installation Instruction

Page: 20 / 24

1 2 3
ON
0
Technical Data
Technical Information
Wiring
Others
HF-Modul/Receiver
Card Plug for receiver module, 433 MHz
FUSE Fuse T10A T10A
Devices for adjustments
Button
„Test/Run“ Runs the operator - OPEN-STOP-CLOSE
Button
„Lern/Learn“ For automatic force setting and registration
of hand transmitters
Maximum Pulling Force 55 kg (+/- 4%)
Force-Setting for Operation automatic
Motor 1V DC, low-noise
Running Speed 14 cm/sec.
Speed in Soft Mode 8 cm/sec.
Lighting 1Vdc, max. 15 watts
Lighting Durance (adjustable) 10 to 300 seconds
Duty Cycle 80%
Accumulator units, Lead, 1V, 1Ah,
Type Panasonic LC-
RA11P
Expected Accumulator Life-Time 3 to 5 years approx.
Power Supply TS Akku II Lead-Accumulator, 1V,
1Ah, Type Panasonic LC-
RA11P
Pre-Warning Light adjustable
Soft-Stop in Closing Direction adjustable
Net Running Length .640 mm
Max. Running Length with Extension
(500 mm) 4.050 mm
Overall Length 3.00 mm
Height Motor Head 180 mm
Length Motor Head 360 mm
Width Motor Head 180 mm
Minimum Space above the door 35 mm
Noise-Emission
≤
60 dB(A)
Internal Wiring
230Vac Blue, mains supply, 30V (N) (N)
Brown, mains supply, 30V (L1) (L1)
Licht/
Lighting Brown+blue, Lighting, 1V
Bat 12V Plug for Battery-Cables
(red cable (+)-Pole, black cable (-)-Pole)
MOTOR Connector for the plug from the motor
PE Earthing from the printed circuit board to the
base plate
Earth Cable
from power
cord The earthing of the mains supply (green/
yellow) is connected to the base plate with a
screw
SOLAR Solar Panel, brown (+) and blue (-)
TS Solar only
Used batteries require a special waste management
Used batteries must be disposed according to national
laws!