Seip TS Akku II, Installation Instruction

Page: 16 / 24

1 2 3
ON
"
!
%
$
#
(
'
&
,
.
3
3
+12V
LS-TST
Gnd
+12 V
Gnd
Gnd
BT Gnd
BT
+12V
LS-TST
Gnd
LS
Gnd
SLZ
8K2
+12 V
N.C.
Gnd
N.C.
+12 V
Gnd
+12V
LS-TST
Gnd
LS
Gnd
SLZ
8K2
+12 V
N.C.
Gnd
N.C.
+12 V
Gnd
16
External Connections
Printed Circuit Board: Adjustments and Connections
Komponente Connector Function
Push Button and
Key Switch BT + Gnd
(A + B)
Floating connector for push button and key switch:no electricity to come into contact
with these connectors!
12V DC Supply „+12V“ + Gnd
(F + H)
1V DC Poewer Supply for external security devices, 150 mAmp. max.
This connector only carries voltage as long as the operators light in switched on; it can
therefore not be used for external remote-receivers!
Receiver-Module HF-Modul /
Receiver-Card Plug for a Seip receiver module
Component
Photocell without self-test
N.C. Connection:
Photocell with self-test
N.C. Explaination: the P.C.B. offers the possibility to check the photo cells functions before the operator starts running. This test is
made by simulating a fault on the photo-cell for 1 Second before every run.
ATTENTION: if the self-testing function shall be used, then the photo cell must be connected as shown below BEFORE run-
ning the learning-cycle - otherwise the self-test will not work!
Advanced Connections
Photo Cell transmitter
Photo Cell receiver
Photo Cell transmitter
Photo Cell receiver