1 2 3
ON
1
2
Bat.
12V
1
Printed Circuit Board: Adjustments and Connections
Devices for Adjustments
TEST-Button (1)
With this button you put the operator into operation. The button
works on the OPEN-STOP-CLOSE principle, e.g. the first push
opens the door, the second push stops the door and the third
push closes the door etc.
The green LED-lamp “TEST“ is switched on as long as you press
the TEST-button and shows that the impulse was received an
recognised by the electronics.
Attention: to use the TEST-button on a factory preset
operator, it first must be set into LEARNING-Mode (indicated
by the operators blinking light). Otherwise the operator will
only run for a short distance and stop with an error-
message.
The TEST-button will work properly, once the operator was
set up and the learning-cycle was completed.
LEARN-Button (2)
This button fulfills the following functions:
1. Learning the forces
. Registering (learning) a hand-transmitter
3. Adjusting the length of the CLOSING Soft-Stop
4. Starting advanced programming functions
The LEARN-button must be pressed for approx. 3 sec.; the button
can be released once the operator‘s light starts blinking. Whilst
the operator‘s light is blinking you can either register a new hand-
transmitter by pushing the hand transmitters button O R you
may start the learning of forces by pressing the button once again.
Details on both procedures can be obtained from the chapters
“Programming Running-Length and Force“ on page
13 and
“Remote Control“ on page 18.
Combined TEST + LERN button functions
Through a combined use of TEST and LERN button the following
special functions can be adjusted:
1. Pre warning light
. Durance of the internal light
How to adjust these functions is explained on page 14 “Special
Functions”.
This page only shows the functions of the buttons and potentiometers on the P.C.B.. To programme the operator ple-
ase refer to page 13 onwards.
Before using the TS-Solar/TS-Akku the battery needs to be
connected to the P.C.B.!
The red and black battery cables are equipped with a polarized
plug which needs to plugged onto the electronics connector
„Bat. 1V“.
Information: red cable (+)-Pol, black cable (-)-Pol
Before Usage: Connecting the Battery Cable
Summary of Contents for TS Akku II
Page 24: ...24...
