87
ADJUST (ADJUST Mode):
Press this button to enter ADJUST Mode. It
also functions as the EXIT button.
W/B switch (white balance):
Select WHITE BALANCE Mode.
WRITING (memory):
Store adjustment data.
R, G, B (color select):
Use to select a color when adjusting color
balance.
CONTRAST:
Adjust the contrast of the projected image.
BRIGHT:
Adjust the black level (brightness) of the
projected image.
TP (test pattern):
Display an internal test pattern.
PHASE (phase adjust):
Adjust the sampling phase.
CLOCK (clock adjust):
Adjust the sampling clock.
POSI (display position):
Adjust the display position of the projected
image.
CAPTURE (adjust image capture):
Adjust timing of image capture.
VIDEO input:
Select video input.
RGB input:
Select RGB input.
DVI input:
Select DVI input.
*1 SERVICE:
Enter SERVICE Mode.
CUT OFF (adjust cut off):
Adjust the white balance of dark areas.
ADJUST (adjust up/down and left/right): Adjusted selected category.
*1 SPECIAL:
Enter SPECIAL Mode.
DRIVE (adjust drive):
Adjust the white balance of light areas.
Summary of Contents for HOUSE OF THE DEAD 4 SUPER DELUXE
