62
8.2. Output
test
Select OUTPUT TEST to display the following screen and check the status of output devices.
This test should be used periodically to check that the lamps are functioning correctly.
Use the SERVICE Button to move the cursor to the desired test item. Press the TEST Button to enter the
selected item's test.
Display of GUN MOTOR1 and GUN MOTOR2 options can be turned on or off using the
DIP-SW.
For cabinets with vibration motors attached to the Control Units (Guns), turn on display
of the GUN MOTOR1 and GUN MOTOR2 under DIP-SW settings to alter these settings.
Perform the tests as follows.
●
START1 LAMP:
Select START1 LAMP and press the TEST Button to turn the option ON.
The player 1 START Button will light up. The lamp will remain on for as long as the
TEST Button is held down.
●
START2 LAMP:
Select START2LAMP and press the TEST Button to turn the option ON.
The player 2 START Button will light up. The lamp will remain on for as long as the
TEST Button is held down.
●
GUN MOTOR1:
Select GUN MOTOR1 and press the TEST Button to turn the option ON.
The player 1 gun will begin to vibrate. The vibration will continue for as long as the
TEST Button is held down.
●
GUN MOTOR2:
Select GUN MOTOR2 and press the TEST Button to turn the option ON.
The player 2 gun will begin to vibrate. The vibration will continue for as long as the
TEST Button is held down.
Move the cursor to EXIT and press the TEST Button to return to the Game Test Mode screen.
Summary of Contents for HOUSE OF THE DEAD 4 SUPER DELUXE
