21
3.6.3. Powering on and software installation.
Caution when using the DVD Drive
Looking directly into the internal laser in the DVD drive may damage your vision.
Never look into the interior of the DVD drive.
When connecting the DVD wire connectors be sure to insert them in the correct direction
and angle.
There is only one correct way to connect them. Attempting to force the connectors together
incorrectly or connecting them at the incorrect angle may damage the connectors or their
pins and create a fire risk or a short circuit.
Be very careful not to trap or damage the DVD wire. This could cause a short circuit or a
fire risk.
Do not use or store the DVD drive or DVD wire in any of the following locations, as this may
lead result in serious damage.
Do not use or store in these locations
Anywhere which may vibrate or shock the equipment
In direct sunlight
In damp or dusty placed
In places with a sharp change in temperature
Close to anything that gives off heat (a heater, etc.)
Close to anything with a strong magnetic field (magnets, monitor, speakers, radio, etc.)
Anyway that is likely to get wet (kitchen, etc.)
Anywhere sloping
Anywhere with corrosive gas in the air (chlorine, hydrogen sulfide, ammonia, sulfur dioxide,
etc.)
Anywhere with strong static electricity
Do not use in these locations
Close to anything that is highly retentive of heat (carpet, sponge, cardboard, etc.)
Anywhere that blocks the DVD drive air vent.
The DVD drive is a delicate piece of equipment. Avoid the following.
Dropping or shaking it violently.
Getting water or other liquids on it, or placing small items on top of it.
Placing large or heavy items on top of it.
Drinking or smoking close to the DVD drive.
Do not turn off the power to the DVD drive when its access lamp is on or flashing, as this
could cause damage to the device.
Do not allow any foreign materials, such as liquids, metals or smoke inside the DVD drive.
Summary of Contents for HOUSE OF THE DEAD 4 SUPER DELUXE
