5
3.
Installation and service instructions
QUALIFIED SERVICE PERSONNEL should only carry out installation and
commissioning of this product.
3.1. Handling
and precautions
When installing or inspecting the machine, be very careful of the following points and pay attention to
ensure that the player can enjoy the game safely.
The game must NOT be installed under the following conditions:
•
Outside, the game is designed for indoor use only.
•
In areas directly exposed to sunlight, high humidity, dust, excessive heat or extreme cold.
•
In locations that would present an obstacle in the case of an emergency i.e. near fire equipment or
emergency exits.
•
On unstable surfaces or surfaces subject to vibration.
•
Where liquids, other than routine cleaning, may come into contact with the game.
Important:
•
This machine should only be installed by Qualified Service Personnel.
•
Be sure to switch the supply power OFF and remove the mains supply plug from the machine before
any work is carried out on the machine.
•
Do not attempt to repair the PCB’s (Printed Circuit Boards) yourself. This will void the warranty. The
PCB’s contain static sensitive devices that could be damaged.
•
Always return a faulty part to your distributor with adequate packaging and protection.
•
When removing the plug from the mains always grasp the plug not the cable.
•
Do not use a fuse that does not meet the specified rating.
•
Make sure all connections are secure before applying power.
Ensure that the mains lead is not damaged. If the mains lead is damaged in any
way there could be a danger of electric shock or a fire hazard.
Ensure that the power supply is fitted with circuit protection. Using the power
supply without circuit protection is a fire hazard.
Summary of Contents for HOUSE OF THE DEAD 4 SUPER DELUXE
