Rev.1.2 – 7.2018.EL950.1.3.1086C
52
one hand pinching the lugs of the shaft. Push the shaft through the back of the vend
motor, freeing up the coil/driver/shaft assembly for removal.
Note:
This operation is more difficult with smaller Coils.
e. Remove the two Phillips head screws that are securing the motor to the product tray.
f. Disconnect Wires of the Vend Motor, paying close attention to the orientation of the
motor plug wire connector.
g. Replace Vend Motor by repeating above steps in reverse order, making sure you plug the
vend motor connector in the same way it was originally.
Note:
Failure to do so may result
in vend motor failure.
PAYMENT SYSTEMS
Coin Changer
The Coin Changer receives and returns change to customers. The Coin Changer will accept Dollar Coins,
Quarters, Dimes, and Nickels. Once the coin tubes reach the required inventory level, all other coins will
be routed into the coin overflow tray.
Loading Changer
As change is given to the customer in coins only, it is recommended that you initially load the coin tubes
completely full when setting up your machine. In order for your VMC to keep an accurate coin inventory,
enter Service Mode by pressing the MENU button and scroll through to QTY/TUBE, and load coins in
through the front coin slot, as if you were inserting money to purchase items. Once the coins start dropping
into the coin overflow tray, that means that the coin tubes are full and the VMC has an inventory of coins
stored and will calculate transactions accordingly. This is also known as priming the changer.
Coin Retrieval
The Coin Overflow Tray holds all accepted coins except for coins needed to maintain inventory in the Tubes.
The User Interface Buttons are located on the upper portion of the changer (Figure 21). When in Service
Mode, go to QTY/TUBE and press a User Interface Button on the changer to dispense the coins in that
tube. Note that the changer will empty that selection of coins. To stop this mode, press the selection’s User
Interface Button again.
Note:
You may also physically remove the Coin Cassette to load and unload coins. Note that doing so will
not maintain audit totals.
