Rev.1.2 – 7.2018.EL950.1.3.1086C
51
Card RDR1 or 2 Comm
VMC does not have communication
with the card reader.
Check MDB Harness to card
reader. Check for power on card
reader.
Card RDR1 or 2 Err
The card reader reports an error
See card reader service manual.
NOTE: Errors are cleared after the problem detected has been resolved.
VEND MOTORS
Each Selection is vended by the action of the Vend Motor. The Vend Motors are screwed onto the rear of
each Product Tray. In the rare event of a jam, a Vend Motor may need to be returned to its home position.
Figure 20 – Motors for Snack Tray and Beverage Unit
1. To “Home “ a Vend Motor
a. Unlock and open the Front Door to access the Circuit Board, and enter Service Mode by
pressing the MENU Button
b. Enter the Test Mode
c.
Enter the letter and number of the motor you wish to home. The motor will rotate to its
home position.
2. To Remove a Vend Motor
a. Unlock and open the front door
b. Unlock Product Tray and pull it out fully while keeping it level
c.
Lift Product tray to release from the Track and pull it out
Caution:
The Product Tray Wire Harness will need to be unplugged prior to complete removal of the
product tray. The wiring harness is plugged into the slide-out shelf in the Snack unit.
d. Remove Coil from the driver by lifting the front end of the Coil up with
Unplug motor
harness
Unscrew two
screws
Pinch to remove
coil driver
Snack Motor
Snack Motor
Beverage Motor
Snack Motor
ELC920
ELC930
Unscrew two blue
thumbscrews
Unplug motor
harness
