MEMO
NEW
CALL#
REPEAT
AM
1
2
3
4
5
6
8
9
7
10
11
12
13
14
15
16
17
18
19
20
21
22
23
OWNERʼS MANUAL —
Please read before using this equipment.
DIGITAL ANSWERER WITH CID
4313385
© 2006 ORBYX Electronics. All Rights Reserved.
IMPORTANT SAFETY INSTRUCTIONS
When using your telephone equipment, basic safety precautions should always
be followed to reduce the risk of fire, electric shock and injury to persons,
including the following:
1. Do not use this product near water, for example, near a bath tub, wash
bowl, kitchen sink or laundry tub, in a wet basement or near a swimming
pool.
2. Avoid using a telephone (other than a cordless type) during an electrical
storm. There may be a remote risk of electric shock from lightning.
3. Do not use the telephone to report a gas leak in the vicinity of the leak.
4. Use only the power cord and batteries indicated in this manual. Do not
dispose of batteries in a fire. They may explode. Check with local codes
for possible special disposal instructions.
5. Position the equipment near an electrical outlet that shall be easily
accessible and plug the adapter into the outlet.
SAVE THESE INSTRUCTIONS!
INDUSTRY CANADA CS03 STATEMENT
This product meets the applicable Industry Canada technical specifications.
This is confirmed by the registration number. The abbreviation, IC before the
registration number signifies that registration was performed based on a
Declaration of Conformity indicating that Industry Canada technical
specifications were met. It does not imply that Industry Canada approved the
equipment.
Before installing this equipment, users should ensure that it is permissible to
be connected to the facilities of the local telecommunications company. The
equipment must also be installed using an acceptable method of connections.
The customer should be aware that compliance with the above conditions
may not prevent degradation of service in some situations. Repairs to certified
equipment should be made by an authorized Canadian maintenance facility
designated by the supplier. Any repairs or alterations made by the user of this
equipment, or equipment malfunctions, may give the telecommunications
company cause to request the user to disconnect the equipment.
WARNING! Users should not attempt to make such connections themselves,
but should contact the appropriate electric inspection authority, or an electrician,
as appropriate.
CAUTION: The Ringer Equivalence Number (REN) assigned to each terminal
device provides an indication of the maximum number of terminals allowed to
be connected to a telephone interface. The termination on an interface may
consist of any combination of devices subject only to the requirement that the
sum of the Ringer Equivalence Numbers of all the devices does not exceed 5.
An alternative indication of the REN is the Load Number (LN); this number
should be divided by 20 to approximate the equivalent REN. The REN Number
of this unit is indicated on the bottom of your answering machine.
INDUSTRY CANADA RSS 210 NOTICE:
CLASS B LIMITS WITH INTERFERENCE
STATEMENT
This equipment complies with the limits of a Class B digital device as specified
in Industry Canada Regulations.
These limits provide reasonable protection against radio and TV interference
in residential areas. However, this device might cause radio or TV interference
even when it is operating properly.
Operation is subject to the following two conditions: (1) This device may not
cause interference, and (2) this device must accept any interference including
interference that may cause undesired operation of the device.
To eliminate the interference, you can try one or more of the following:
•
Reorient or relocate the receiving antenna.
•
Move your device away from the receiver.
•
Connect your device to an outlet that is on a different electrical circuit
from the receiver.
This digital apparatus does not exceed the Class B limits for radio noise
emissions from digital apparatus.
BATTERY NOTES
Dispose of old battery promptly and properly.
Do not burn or bury battery.
Use only fresh battery of the required size and recommended type.
If you do not plan to use the phone for two weeks or longer, remove the
battery. Batteries can leak chemicals that can destroy electronic parts.
To avoid losing stored information, be sure the system is properly connected
to AC power before you replace the battery.
Disconnect the telephone line cord before replacing the battery to reduce
the risk of fire or injury.
TM
MC
1. Line Cord
2. Incoming Message Length
Switch
3. Call Back Button
4. Display
5. Erase Button
6. Microphone
7. Volume Button
8.
/ OGM Button
9. Play / Pause button
10. Menu Button
11. Delete Button
12. Ringer Switch
13. Power Jack
14. Telephone Line Jack
15. New Call LED
16. Review Button
17. Review Button
18. Speaker
19. Message LED
20.
/ Time Check Button
21. Memo / 2 way Button
22. On / Off / Stop Button
23. Volume Button
