Rev.1.2 – 7.2018.EL950.1.3.1086C
9
COIL ADJUSTMENT
If you are required by a location to vend a product that does not fit into the standard coil installed, you
may need to order a different coil and install it. To replace a coil:
1. Remove the Coil from the Coil Driver by lifting the back of the coil up off the coil driver. You will
need to move the bottom of the coil clear of the coil driver to completely remove the coil. See
Figure 7.
2. Align the new coil end with the front of the tray, which gives the coil better contact with the
product. The position of the coil in the coil driver is adjustable to assist you in aligning the new coil
at the front of the tray. See Figure 8.
Figure 8 – Removing and Aligning a Coil
If you are experiencing vending issues with certain products, you may need to adjust the coil rotation to
better provide the momentum to push the snack off the tray and into the delivery area. To adjust the coil
rotation:
1.) Squeeze the two tabs on the back of the coil driver and pull the coil driver and coil toward the front
of the tray to remove it.
2.) Turn the coil clock-wise 1/8 of a rotation.
3.) Reinsert the coil driver with coil attached back into the motor, through the back wall of the tray.
4.) Load the tray and perform at least 5 (five) test vends to insure a proper vend.
5.) If the item does not vend consistently, repeat another 1/8 of a rotation until you are confident of
consistent vend function.
Figure 9 – Coil Rotation Adjustment
Coil Driver with
three (3)
adjustment
options
Lift Coil
Apply pressure to
the straight part of
the coil that is
inserted into the
Coil Driver. Lift up
on the Coil to
remove.
Back of Product
Tray, Snack or
Entree
Squeeze two tabs
on the back of the
Coil Driver
Pull the Coil Driver
and Coil forward;
Rotate 1/8 of a
turn and reinsert
back into product
tray.