Rev.1.2 – 7.2018.EL950.1.3.1086C
48
3.
Enter selection to test and wait
Selection: (Current Selection)
*-Delete
4.
Repeat for any other selections or
Selection: (New Selection)
*-Delete
8.
Press * to exit to Sales Mode
0.00
9. SELECTION: ALL
This function tests all motors in sequence automatically. To stop the test, press * to exit. NOTE:
All selections should be empty prior to performing this test.
STEP
DISPLAY
1.
Press Service Mode Button
Motor Count or Error Code **
2.
Press 9 for Selection motor test menu
Selection: (First Selection)
*-Stop
3.
Press * to exit to Sales Mode
0.00
10. TEST MODES
This menu contains diagnostic tests and settings for the following systems:
•
Relays
•
System Logs*
•
Vigilant Vend Sensor
•
On Door
•
Drop Bias Setting*
•
Manual Defrost
STEP
DISPLAY
1.
Press Service Mode Button
Motor Count or Error Code **
2.
Press 0 for Test Modes
Test Modes
3.
Press 1 to test relays; then press 1-6 to test each relay.
Press 2 for vend sensor alignment test.
Press 3 then password 2314 for log. NOTE: Do not use
unless requested by trained personnel.
Press 4 and toggle ON/OFF to show errors when door
opens.
Press 5 for Manual Defrost, which will enable you to set a
manual defrost period for the machine. NOTE: Do not use
unless requested by trained personnel.
Test Modes 1 through 5
4.
Press * to exit to Sales Mode
0.00
ERROR CODE MESSAGES
VMC Errors
Error Message
Description
Possible Solutions
VMC Settings Reset
VMC has been reset to factory
default.
If a software upgrade has just
been performed, the VMC has
been reset to default settings.
Change your prices and other
settings as required. Cycle power
and verify your changes and any
error messages.
VMC Door Switch
Door switch is seen as open for
greater than the allowed time.
Check the door switch for correct
operation. Check door wire
harness.
