Screen Print & Inkjet Fast T-Jet Blazer Pro, User Manual

Page: 26 / 138

Release the Green shipping tab lock located at the base
of the Print Carriage.
Plug the Unit into AC Power
Plug the printer into its own power source. The Fast T-Jet Blazer Pro has a dual
voltage power converter built in, allowing it to work with 50 or 60 cycle current
ranging from 110 volts to 220 volt.
DO NOT TURN THE PRINTER ON YET! YOU MUST FIRST INSTALL THE BULK INK SYSTEM.
Insert the AC cord into the unit and plug the opposite end into a power strip with
surge protection. Avoid plugging multiple items into the same power strip.
For more reliable results, plug the unit into a UPS (Uninterruptible Power Supply)
to help prevent ruined shirts during power fluctuations. DO NOT plug other high
power use items, such as a Heat Press, into the same circuit.
Powering Your Printer ON and OFF
When turning ON your Fast T-Jet Blazer Pro, you must first turn on the Main Power
Switch (located adjacent the AC cord). Wait until the virtual LED labeled
“Automatic Mode” becomes Red and then press the Power On ( Orange )
button.
This takes approximately 5 seconds.
When turning OFF your Fast T-Jet Blazer Pro, you must press
the Power (Emergency) Off button ( Red ) on the UI before
turning OFF the Main Power Switch (located adjacent the
AC cord). When powering OFF, your printer goes through
a shut down cycle that seats the head onto the Capping
Station to help prevent Print Head clogs. DO NOT turn off
the unit at the power strip. It WILL NOT go through a normal
shut down.
The virtual LED turns red after 5 seconds
12
Fast T-Jet Blazer Pro User’s Manual
Main Power Switch