Screen Print & Inkjet Fast T-Jet Blazer Pro, User Manual

Page: 129 / 138

Receive the equipment properly. Use appropriate personnel and equipment
to off-load and move the shipping containers to a storage area or directly to
a staging area. The Fast T-Jet Blazer Pro ships in a single crate that is large and
must be handled with the use of a forklift, lift gate or pallet jack. The crated
printer and components weigh over 500 pounds (227 kg).
Before moving shipping containers from the receiving area, check corridors and
doorways for clearance and remove any obstacles. The printer must have a
doorway clearance of a minimum of 36 inches (92 cm).
Make sure the preparations for the system set up are complete. It is essential to
have all utilities (HVAC and electrical) available at the time of installation. Use
trained personnel to assist with the installation in each of these areas. The Fast
T-Jet Blazer Pro printer must be on a dedicated power line that has at least 15
amps. It can be hooked up to 110v or 240v service. It is dual voltage.
Agree to perform simple Daily and Weekly Maintenance procedures outlined
in the User’s Manual, including keeping the Print Head and Capping Station
cleaned.
Room Preparation
The first step in preparing the workspace is to plan the location of each system
component. Make a complete list of all equipment and supplies to be
accommodated in your garment printing area and define the workflow
between this equipment. Identify efficient operational techniques.
Environment
The printer will operate best in a clean, dust-free room at a steady temperature
between 68° F and 85° F (20° C and 29° C) with a relative humidity between 40%
and 80% (non -condensing).
Operation of the printer at a relative humidity below 40% or above or below the
recommended temperature range will result in poor nozzle print performance
and poor print image quality. This may result in the User voiding the warranty.
The workspace floor should be easily cleaned and should not generate dust or
static electricity. It should be noted that decorating the room in neutral gray
colors and using pure white (“daylight”) lights would aid operators and clients in
judging color accuracy.
Ideally, the Fast T-Jet Blazer Pro printer should not be installed in the same room
as other equipment that can potentially cause an ink mist or excessive dust. This
115
Appendix A- Operational Guide