Screen Print & Inkjet Fast T-Jet Blazer Pro, User Manual

Page: 23 / 138

Casters have been built into the cabinet base, allowing for easy movement to
a suitable location within your shop. When determining where to set up your
printer, keep in mind the Fast T-Jet Blazer Pro requires an area of at least 12 ft x
10 ft (3.6 m x 3.6 m) for the printer and workspace around it. Additional space is
required for drying, pretreating garments, garment staging, etc.
Note: Remove any obstacles. All doorways and corridors the printer will travel
through must be at least 36 inches (92 cm) wide.
When the Blazer Pro reaches its final destination,
manually lower the ground supports on all
four corners. Using a box level (found at any
hardware store), check the Print Bed to ensure it
and the machine are level. Each ground support
is threaded and can be raised or lowered to
make any needed height adjustments. Once
you have leveled the machine, tighten each
locking nut against the bottom of the cabinet
base.
Installing the User Interface
The User Interface (UI) controls basic printer operation
and is touch sensitive. To install the UI you will need a
5mm Allen wrench
Unpack the User Interface and locate the (2) 5mm hex
screws for installation.
Position the extension bracket along the back of the machine as shown below.
Using the Allen wrench, secure the extension bracket to the printer base.
Connect the UI Serial Port Cable to the cabinet base.
Locking Nut
Ground Support
9
Chapter 2- Unpacking and Setup