14
496256 Issue 1
3. After an Alarm
Customer Reset
From Keypad
1.
Key-in your access code and press Enter.
The keypad displays:
SYSTEM RESET OK
followed by the date and time.
You can now use your system as normal.
If the keypad displays (for example):
CANNOT RESET
02 FAULTS EXIST
then a detector may still be triggered,
or the anti tamper protection on your system may
be damaged.
1.
Press A or B to see any more faults.
2.
Contact your alarm company.
Using a Keyswitch
If your system is fitted with a momentary (springloaded) keyswitch you can
reset the system as follows:
1.
Turn the key to Arm and release it back to Off.
The sounders go quiet.
2.
Turn the key to Arm again and release it back to Off.
You can now use your system as normal.
Engineer Reset
1.
Key-in your access code and press Enter.
The keypad displays a message to call your
company, for example:
CALL ENGINEER
0123 456789
2.
Call your alarm company and ask them to come and reset the system.
Remote Reset (CSID Code)
If your system uses remote reset, the display shows the words "CONTROL
CODE" and a four digit code on the bottom line.
1.
Write down the four digits shown below the words "Control Code".
2.
Contact your alarm company central station.
The central station will ask a few questions to make sure you are who
you say you are. They will then ask for the circumstances of the alarm.
If they do not need to send an Engineer to check the system they will
give you a "Reset Code".
3.
Key in the Reset Code on the keypad.
