10
496256 Issue 1
1.
Close all doors and windows.
2.
Key in your access code at the keypad.
3.
Press the appropriate Level button followed by Enter.
The system sets immediately. The Level LED glows to show which
Level is set.
Keyswitch Setting
1.
Close all doors and windows.
2.
Check that the Ready lamp on the keyswitch is glowing, if your keys-
witch is fitted with one.
If the lamp is not glowing then one or more detectors are being trig-
gered.
3.
Turn the keyswitch (normally fitted outside the protected area).
Depending on how your system is programmed, the system may set
instantly or after a fixed delay, or when you close a final door or press
an exit terminate button.
Note that some keyswitches have two setting positions: "Full" and "Part". Ask
your Installer which parts of your premises are covered by each of these
positions.
Setting an Area
Your system may be set up so that each Level key covers several distinct
Areas. You can set the system to guard one Area in a Level but leave the
others unset. Ask your Installer which Areas are covered by each Level key.
To set an Area:
1.
Close all doors and windows make sure everyone is out of the area.
2.
Key in your access code at the keypad.
3.
Press the appropriate Level button.
4.
Key in the Area number followed by Enter.
The keypad starts the continuous exit tone, the
Level LED flashes, and the display shows:
AREA READY
LEAVE
Depending on how your system is programmed, the system may set
instantly or after a fixed delay, or when you close a final door or press
an exit terminate button.
If the System Will Not Set
If the end station has detected a problem with one or more of the detectors
then the keypad will give a "beep" and show either a
fault
or a
trouble
message.
2. Everyday Operation
