496256 Issue 1
33
6. Supervisor
4.
Press Enter.
The display shows the cursor at the beginning of
the bottom line:
U02:P01:
NO ACCESS
5.
Press A or B to change access to the Partition.
The display shows (for example):
U02:P01:
HAS ACCESS
6.
Press Enter.
The display shows the next Partition (for example)
U02:P02:
NO ACCESS
7.
Repeat steps 4 to 6 to give the correct access to all four Partitions.
When you press Enter after changing access
for Partition 4 the top line of the display shows:
U03:DURESS CODE
DISABLED
Don't forget to tell each user which Level key they must use for each Parti-
tion, or that keying in their access code followed by Enter sets the highest
Level assigned to their access code.
Setting Up a Duress Code
A duress code is a special access code used for emergencies only. After
entering a duress code the system does not allow access to any of the
special functions listed in section 4. In addition, the system will not let you
give User 01 a duress code.
1.
Start menu 8.
2.
Press Enter until the top line of the display shows "U01:CODE=".
3.
Press A or B until the display shows the user number you wish to use
for the duress code (or key in the number directly).
The display shows (for example):
U14:CODE =
****
4.
Press Enter.
The display shows:
U14:CODE=
_
5.
Key in the duress code and press Enter.
The display shows:
CONFIRM NEW CODE
_
6.
Key in the duress code again.
When you key the last digit of the duress code
the top line of the display shows:
U14:P01:
