32
496256 Issue 1
6. Supervisor
code you wish to change. (You can also key in the user number if you
already know it.)
The display shows (for example):
U02:CODE =
****
Note: If your system is using six-digit access codes the bottom line of the display will
show "******".
4.
Press Enter.
The display shows:
U02:CODE =
_
5.
Key in the digits of the new access code and press Enter. Note that the
display shows "
*
" characters instead of numbers. This is to prevent
anyone reading the access code over your shoulder.
Note: To delete an existing code key in "0000" ("000000" for six digit access codes).
The display shows:
CONFIRM NEW CODE
_
6.
Key in the same digits again.
After you key in the last digit the display
changes to show (for example):
U02:P01:
NO ACCESS
If the display shows:
CODE MISMATCH
then you did not key in the confirmation correctly.
Press Menu and go back to step 4.
If the display shows:
CODE ALREADY
IN USE
then another user already has that access code.
Press Menu and go back to step 4.
Changing Partition Access
If your system does use Partitions then once you have created a set of
access codes you must then give them access to the appropriate Partition(s).
Each access code will then work only on the Partition(s) you have assigned.
Ask your Installer which Partition (1, 2, 3, or 4) is assigned to each of the
Level keys. Then:
1.
Start menu 8.
2.
Press Enter until the top line of the display shows "U01:P01:".
3.
Press A or B until the display shows the user number whose Partition
access you wish to change (or key in the number directly).
The display shows (for example):
U02:P01:
NO ACCESS
