496256 Issue 1
31
6. Supervisor
2.
Press
Menu
followed by
8
.
The display shows:
8: USER
INFORMATION
3.
Press Enter.
The display shows:
EDIT USER
INFORMATION ?
Changing User Names
The 8136 can store a 16 character name against each user code. To change
the name:
1.
Start menu 8.
2.
Press Enter until the top line of the display shows: "U01:NAME ="
3.
Press A or B until the top line of the display shows the user number
whose name you wish to change. (You can also key in the user number
if you already know it.)
The display shows (for example):
U03:NAME =
NOT IN USE
4.
Press Enter.
The display cursor moves to the bottom line:
U03:NAME =
NOT IN USE
5.
Key in the new name. Use the in the same way as you would for chang-
ing the zone names (see Figure 2).
The display shows the new name (for example):
U03:NAME =
MARY_
6.
Press Enter when you have completed the name.
The system stores the name and the display shows "U03:CODE ="
7.
Press Menu three times to leave programming.
Changing Access Codes
The Installer can program your system to use either four-digit or six-digit
access codes. Check with the Installer which type of code is in use.
If your system does NOT use Partitions, but is simply a Full/Part set system,
then all access codes apply to all Levels. You cannot assign any access code
to a specific Level.
1.
Start menu 8.
2.
Press Enter until the top line of the display shows "U01:CODE =".
3.
Press A or B until the display shows the user number whose access
