496256 Issue 1
19
If any detector fails the test then call your alarm company and ask them to
check the system.
Note:
If your system is fitted with Fire, 24 hour or personal attack detectors, you
cannot walk test them. If you wish to test them call your alarm company.
Walk Test
1.
Key in your access code.
2.
Press
Menu
followed by
4
.
The display shows:
4: TEST OPTIONS
3.
Press Enter.
The display shows:
WALK TEST
4.
Press Enter.
The top line of the display shows the total
number of detectors to test, while the
bottom line shows the zone number of each
detector to be tested, for example:
13 ZONES TO DO
01 02 03 04 05 06 >
5.
Walk round your premises and trigger each detector. Note: do not
trigger any Fire, 24 hour or personal attack detectors (they will not
appear in the list of detectors to be tested). If you do trigger a Fire, 24
hour or personal attack detector the system will raise an alarm.
As you trigger a detector the internal sounder gives a tone, and the zone
number disappears from the display.
If necessary press A or B to scroll through the list of zones to show any
not appearing on the display.
When all detectors shown on the list have been
tested successfully the display shows:
WALK TEST
COMPLETE
Note:
You can abandon the test at any time by pressing Menu.
Bell Test
1.
Key in your access code.
2.
Press
Menu
followed by
4
.
The display shows:
4: TEST OPTIONS
3.
Press Enter.
The display shows:
WALK TEST?
4.
Press
B
The display shows:
BELL TEST ?
4. Special Functions
